'82 131 Superbrava & parts.

Post up your items for sale here.

'82 131 Superbrava & parts.

Postby Super Brava » Fri Feb 03, 2017 6:15 am

I’ve decided to sell my 131, good ones are hard to find, and this is a pretty good one. Besides the car there is a plethora of spares, as I’ve wrecked 4 x 131s in the last 10 years.

I’ll try and remember all the bits I’ve put on the car.

Bored 84.6mm, new HC pistons, new rings and bearings.
Head overhauled. New guides, stainless exhaust valves, 290 inlet cam, 281 exhaust.
MLS gasket and ARP studs.
Adjustable cam gears.
40 IDFs on waffle manifold, original IDF aircleaner, (butchered by PO owner, air horns cut off).
Fiatorque extractors and 2” exhaust.
Crane Hi6 ignition and Bosch HEC coil.

New windscreen.
Recored radiator.
Regata 100S calipers and discs.
132 disc rearend.
Pagid pads front and rear.
Koni yellow adjustable shocks front and rear.
Heavy duty lowered springs front and rear.
15” x 6” wheels with 195/50/15 rubber.
EFI stuff:.
Surge tank.
Bosch HP pump.
LP pump.
Megasquirt2 ECU.
MS Relay board.
O2 sensor and controller.
36-1 trigger wheel mounted on crank pulley with blower serpentine pulley.
Tempra manifold with rail and new 320cc injectors.
New adjustable fuel pressure regulator.
Parts in the shed:
2 litre bottom end, virgin bore.
2 litre motor, virgin bore, about 20k/kms on LPG after new rings and bearings.
2 litre block, bored 0.6mm, decked, new bearings, Eaton M45 attached.
Regata 100S head, overhauled and ported by Fiatorque.
NOS Croma turbo 84.6mm pistons. (in box)
H beam rods. (in box)
2 x intercoolers. 1 x Ford XR6, 1 x Landrover.
4 x 131 gearboxes.
131 rearend.
Argenta rearend.
Croma manifold.
New recirculating dump valve for blower.
NOS Croma throttlebody.
2 x throttlebodies.
New Valeo clutch kit.
New Integrale clutch and pressure plate.
Lightened flywheel.
Stock flywheel.
Complete Superbrava wiring loom.
2 x cam mounted electronic distributors.
Roof lining.
Boot lid with spoiler.
Front and rear screens.
Aircon/heater box and controls plus under dash wiring loom.
7 x doors.
3 x Instrument cluster.
4 x 13” alloys.
4 x 14” alloys.
ADM weber on 131 manifold.
Bolt only rods x4. (1 spun bearing)
Early cross member.
Early steering rack.
131 inlet and exhaust manifolds.
Beta inlet manifold.
8V turbo manifold.
OEM NOS engine & gearbox mounts.
Decompression plate. 2mm stainless.
2 x new water pumps.
New external thermostat.
Twinfan radiator. (Needs rodding or recore)
Rear lower control arms, nolathane bushes.
3 x heads. (2 unknown)
Various seatbelts.

Plenty of other bits, looking and counting is depressing.

Everything located in Hobart.
$10k the lot. Not interested in selling bits and pieces.
With an M45 you'll all be eaton my dust.
User avatar
Super Brava
Posts: 2845
Joined: Wed Oct 27, 2010 6:28 pm
Location: Hobart.

Return to Classifieds

Who is online

Users browsing this forum: No registered users and 1 guest